Most plumbers wont mess with the septic tank. We deal mostly with components inside the house. Did you have a vent pipe in the yard (often looks like a candy cane made of PVC) before the repair but not after? If all he did was replace the line it shouldn't cause a smell inside the house. All plumbing fixtures inside the house should have properly functioning traps. Those traps would create and maintain a water seal against the sewer gases. You should have at least one vent through the roof to equalize pressures within the drainage system. This prevents positive pressures within the system (caused by fixtures discharging into the lines, ie toilet flush) from pushing gas out through the traps, and negative pressures (the waste in line will pull air behind it like your finger over the end of a straw) from sucking water out of the traps.
At Steve’s Plumbing Service, our Oahu plumbers are highly skilled at customizing your plumbing system to you and your family’s unique needs. Whenever you are remodeling your home, you have a great opportunity to improve the comfort that your home provides and the uses to which you can put your home. Our plumbing professionals can install plumbing fixtures and appliances that will enhance both of these aspects. Maximize the benefits of your next remodeling project by hiring our highly skilled professionals.
Sometimes, a repair job isn’t quite enough. When this happens, we offer expert plumbing installation services from our professional plumbing contractors. We strive to offer customers high-quality water heater installation service, water heater replacement, home water filtration installation, and more. We always suggest the most cost-effective repair or installation options to make sure that our solution meets your needs and your budget.
Help! The toilet won’t stop running. It’s a bummer, sure, but it’s something you don’t need to call your plumber about. In fact, DIYers should take note that it’s a quick fix that will cost you just $5. For instance, your handle might just be sticking, which can be solved by spraying some lubricant where the handle meets the porcelain. Ready to DIY? Here’s how to fix a running toilet.
Wall thickness does not affect pipe or tubing size. 1/2" L copper has the same outer diameter as 1/2" K or M copper. The same applies to pipe schedules. As a result, a slight increase in pressure losses is realized due to a decrease in flowpath as wall thickness is increased. In other words, 1 foot of 1/2" L copper has slightly less volume than 1 foot of 1/2 M copper.
Hello my name is Sam and I have been in the home renovation and remodeling business as well as swimming pools for over 25 years. I grew up in a family that owned skilled trade businesses. I possess abilities in all facets of the trades including but not limited to carpentry, plumbing, electrical, and more. I also have strong knowledge of home automation for lights and appliances.
Leaky faucets are more than just a minor inconvenience. All that dripping water can corrode your sink and drain basins, wear away at your pipes and waste hundreds of gallons per year! Don’t let this happen to you – call our friendly Baltimore, Washington D.C., Northern Virginia, Delaware and the Philadelphia plumbing technicians for faucet repair today!
We've talked before about home electrical projects you can handle on your own and now it's time to tackle plumbing. The projects we're covering here mostly deal with repairing things like running toilets and leaky faucets, and replacing fixtures like faucets and shower heads. These are beginner-level projects that are fairly easy to do and can save you a lot of money if you tackle them yourself.
Although plumbers, pipefitters, and steamfitters perform three distinct and specialized roles, their duties are often similar. For example, they all install pipes and fittings that carry water, steam, air, or other liquids or gases. They determine the necessary materials for a job, connect pipes, and perform pressure tests to ensure that a pipe system is airtight and watertight. Their tools include drills, saws, welding torches, and wrenches.
The straight sections of plumbing systems are called "pipes" or "tubes". A pipe is typically formed via casting or welding, whereas a tube is made through extrusion. Pipe normally has thicker walls and may be threaded or welded, while tubing is thinner-walled and requires special joining techniques such as brazing, compression fitting, crimping, or for plastics, solvent welding. These joining techniques are discussed in more detail in the piping and plumbing fittings article.
Hi Kenneth, We would be happy to get you connected with a pro for your project. You can submit a service request on our website: http://www.homeadvisor.com/, or browse reviews for local water heater pros here: http://www.homeadvisor.com/c.html. We can also have a project advisor reach out to assist you if you send your contact information to [email protected] –HASupport
The video above from Lowe's shows how to fix leaks in all three types of single-handle faucets. Basically, you're going to remove the handle, pop out the mechanism, and replace it or the surrounding seals. If you can spot which part is causing trouble, you can buy each of the pieces individually. Otherwise, you can buy a faucet repair kit for that type of faucet and replace everything at once. Neither option should be very expensive.
If nothing inside the home was altered you should not be getting a smell. Personally I'm confused as to why the repair person would have left the original line there and ran another one through a new hole. I would have pulled the old line up, ran the new line (in PVC) and used the same hole in the septic tank instead of creating a new one. Did he seal up the hole in the tank from the old line?
We actually have our own guide on this, but the above video from Lowe's is a good basic guide too. Do make sure to read the installation instructions that come with the faucet, though. Sometimes, there are important variations. We've only included a video on kitchen sinks here because the process of installing a bathroom sink is largely the same. However, you can always check out this video from RONAinc if you want to see the process.
Some allege that putting a brick in the toilet tank can save water, but doing that can keep your toilet from flushing correctly. Another plumbing tip, avoid liquid drain cleaners. Liquid drain cleaners are also bad news—they eat away at the pipes. Try a plunger or, better yet, a $30 auger. Don’t have either? Here’s how to unclog a toilet without a plunger.
Happy Spring 2018 Grand Prairie! We are still your #1 rated plumbers in all of Grand Prairie. Remember to follow us on Facebook for all updates. For any water damage needs you have in your home or business give us a call today. Leaky faucets or clogged drains, our skilled licensed plumbers can help you. We look forward to serving you in 2018 and beyond.
toilets work off of siphon.more correctly it's the timely transfer of water from the tank to the bowl through the ports that starts the siphon and carrys the solids and water downstream,thus completing a flush.i also live in florida and due to lots of hard water everywhere can tell you that most likely the toilets are full of deposits and need to be replaced or are of poor quality.all of the toilets from home depot are trash i would suggest getting one from the factory or from a plumbing supply house.DO NOT GET A 1.28gpf...1.6gpf is still legal
We offer several financing options for new equipment, as well as our Priority Club Membership that grants members exclusive discounts, priority service, annual tune-ups, and much more. Plus, we make it our mission to give back to the community that’s continually supported us for decades. Our team members regularly donate their time, money, and efforts to numerous charitable organizations, fundraising endeavors, and worthwhile causes throughout the Northern Virginia and suburban Maryland area.
My Mom is in her eightys. I called a plumber in Aug 2012, replaced the McDonnell/Miller LWCO low water cut off 47/2 $675.. Same plumber was called Jan 8,2013 back. He trouble shoot the problem and replaced the same unit, yet I still have the problem. After the heat come on for about 15 mins/ goes off.the pipes connecting to the MM LOCO the vibrating starts, shakes, and makes a loud noise. The boiler is steam, I know it's old. Do I call the same plumber or call someone differently?
It’s a family event in late October when many American households carve a pumpkin into a Halloween jack-o-lantern. The kids delight in the whole process, especially when mom and dad let junior scoop the pumpkin pulp out of the pumpkin. But what happens next is the scary part. Often, those slimy pumpkin guts are pushed down the sink drain then the disposal is turned on to chop it into tiny bits before the water washes it away. Except, it doesn’t quite ... Read More >
When you’re searching for a dependable Dallas plumber or Dallas plumbing company “near me” which offers licensed and trained plumbers for any plumbing repair or plumbing installation like water heaters, tankless heaters, garbage disposals, drain or sewer lines, water filtration, water softening or other plumbing needs, call 214-324-8811214-324-8811.
Plumbers in Australia have licensing requirements that differ from state to state but it is generally accepted a 4-year apprenticeship with a further minimum experience of 2 years (6 years total) and a further curricular requirement as a benchmark for licensing. Licensed plumbers are also expected to maintain minimum relevant training requirements to maintain their plumbing license