Pro Plumbers

The difference between pipes and tubes is simply in the way it is sized. PVC pipe for plumbing applications and galvanized steel pipe for instance, are measured in IPS (iron pipe size). Copper tube, CPVC, PeX and other tubing is measured nominally, which is basically an average diameter. These sizing schemes allow for universal adaptation of transitional fittings. For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing. 1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded male or female adapter to connect them. When used in agricultural irrigation, the singular form "pipe" is often used as a plural.[19]
Rick’s Plumbing has been a mainstay within New Haven and Fairfield Counties since 1992. As a premier local plumbing service, we have been around for the community to complete any type of job – big or small. We only hire skilled professional plumbers to complete each task for our customers, ensuring the highest level of service is achieved within the shortest time possible. Whether you are looking for plumbing service or heating service, we’ve got you covered.

In addition to Trenchless Technology, Our licensed technicians and OSHA certified excavation crews specialize in traditional tunneling and sub-slab plumbing repair / replacement.  Detailed analysis and fixed cost proposals for repair are provided to customer upon completion of a hydrostatic pressure test and diagnostic slab leak testing, using a combination of cutting-edge pipelining techniques with traditional excavation to fix foundation leaks while minimizing digging and added expense.  Traditional tunnels or trenches for water line repair or sewer repair are hand dug by crews with confined space training.
Most plumbers wont mess with the septic tank. We deal mostly with components inside the house. Did you have a vent pipe in the yard (often looks like a candy cane made of PVC) before the repair but not after? If all he did was replace the line it shouldn't cause a smell inside the house. All plumbing fixtures inside the house should have properly functioning traps. Those traps would create and maintain a water seal against the sewer gases. You should have at least one vent through the roof to equalize pressures within the drainage system. This prevents positive pressures within the system (caused by fixtures discharging into the lines, ie toilet flush) from pushing gas out through the traps, and negative pressures (the waste in line will pull air behind it like your finger over the end of a straw) from sucking water out of the traps.
Hello, long story. Toilet line stopped up two years ago. A company used high pressure water to clean line. Didnt work. Came back a second time with a plummer. Spouse was told that the line had collapsed, filled with rocks or tiles. Plummer then disconnected that line put in a second line, punched a hole in my tank, fed the new line in that hole. Now two years later, each heavy rain brings a strong sewer smell into the house. Found out later that there were no rocks or tiles in original line, only a large calcium build up over 25 years that had clogged the original line. I do not know if when the new line was put in, the old line was closed properly or if either line was or should be vented? I would like the original line reconnected and the newer line just removed. I plan then to repair the hole in septic tank where the new line entered with tar or concete. I need someone to fix my smelly home.
Much of the plumbing work in populated areas is regulated by government or quasi-government agencies due to the direct impact on the public's health, safety, and welfare. Plumbing installation and repair work on residences and other buildings generally must be done according to plumbing and building codes to protect the inhabitants of the buildings and to ensure safe, quality construction to future buyers. If permits are required for work, plumbing contractors typically secure them from the authorities on behalf of home or building owners.[citation needed]

Plumbing is any system that conveys fluids for a wide range of applications. Plumbing uses pipes, valves, plumbing fixtures, tanks, and other apparatuses to convey fluids.[1] Heating and cooling (HVAC), waste removal, and potable water delivery are among the most common uses for plumbing, but it is not limited to these applications.[2] The word derives from the Latin for lead, plumbum, as the first effective pipes used in the Roman era were lead pipes.[3]
×