Pro Plumbers

We have been around for nearly a century! Established in 1920, Bud’s Plumbing & Repair Service knows the exact needs of Evansville residents and commercial property managers. We know what products work best with certain properties, which solutions will give you the best value for your money, and what you can do to prevent the same problem from recurring.
“Don’t assume that every Mr. Fix-it advertising his services in the local Pennysaver or on Craigslist is a licensed plumber,” says one New York plumber. There is no national standard for issuing licenses. Some plumbers are licensed by the state, others by the counties they work in. Check with your local city hall or chamber of commerce. They should be able to direct you to the appropriate source for a list of licensed plumbers in your area.

Most plumbers wont mess with the septic tank. We deal mostly with components inside the house. Did you have a vent pipe in the yard (often looks like a candy cane made of PVC) before the repair but not after? If all he did was replace the line it shouldn't cause a smell inside the house. All plumbing fixtures inside the house should have properly functioning traps. Those traps would create and maintain a water seal against the sewer gases. You should have at least one vent through the roof to equalize pressures within the drainage system. This prevents positive pressures within the system (caused by fixtures discharging into the lines, ie toilet flush) from pushing gas out through the traps, and negative pressures (the waste in line will pull air behind it like your finger over the end of a straw) from sucking water out of the traps.
Let's start with the easiest possible project: Installing a new shower head is as simple as it gets. Typically, all you have to do is unscrew the old shower head from the shower arm (the pipe coming out of the wall), clean off the threads on the shower arm and wrap a bit of Teflon tape around it, then screw on the new shower head. It's really that simple (and if you don't believe me, check out the video above from Dummies.com). Do read the installation instructions on the shower head you buy, though. Some are designed not to require Teflon tape and can actually leak if you use it.

plumbers must be asked directly what they charge hourly and if that is in addition to a service charge. The two are separate and I think they have gotten away with outrageous charges because of the potential of water damaging homeowner structures.   I had a plumber (not Home advisor) come and replace a part in my kitchen sink that was under warranty---the spray nozzle had been leaking...He charged me $85.00 for 15 minutes of work and I will never use Mr King again. 
While it’s their job to make sure your pipes work like a well-oiled machine, it’s not their job to rebuild the wall they had to demolish to make that happen. So, while you’re going to get that water problem fixed, you’ll want to discuss in detail what kind of “mess” they might leave behind prior to the start of the project so you can plan accordingly. Remember, there are some jobs you can do yourself. Here’s how to solder copper pipe joints!

With experience and expertise, your plumber will be able to inspect your plumbing fixtures and identify where any problems may have originated. With the right tools on hand, they’ll be able to fix the problem, right there and then. If your water heater has  triggered a full-blown flood, they’ll know exactly how and where to shut off the water supply. Should the flood be the result of a burst pipe, they’ll be able to change it before it can do any additional damage. Plumbers know a lot about their craft that we do not, and the Handy platform gives you the opportunity to book them and benefit from their knowledge and ability.
The video above from Lowe's shows how to fix leaks in all three types of single-handle faucets. Basically, you're going to remove the handle, pop out the mechanism, and replace it or the surrounding seals. If you can spot which part is causing trouble, you can buy each of the pieces individually. Otherwise, you can buy a faucet repair kit for that type of faucet and replace everything at once. Neither option should be very expensive.

In addition to Trenchless Technology, Our licensed technicians and OSHA certified excavation crews specialize in traditional tunneling and sub-slab plumbing repair / replacement.  Detailed analysis and fixed cost proposals for repair are provided to customer upon completion of a hydrostatic pressure test and diagnostic slab leak testing, using a combination of cutting-edge pipelining techniques with traditional excavation to fix foundation leaks while minimizing digging and added expense.  Traditional tunnels or trenches for water line repair or sewer repair are hand dug by crews with confined space training.
Todd did an amazing job, and fixed a problem that could of been devastating. Replacing a leaking water heater and also a replacing a failing, leaking main shut of valve. The possibility of major flooding was a real danger It was a 12 unit townhome which made the job even trickier, as water had to be shut off to the entire building while he fixed the valve. Todd, replaced them quickly and expertly, without a hitch. Plumbing repairs are never fun for a homeowner, but these people (especially Todd) do great work. It is definitely a weight lifted off my chest.
The word "plumber" dates from the Roman Empire.[3] The Latin for lead is plumbum. Roman roofs used lead in conduits and drain pipes[4] and some were also covered with lead, lead was also used for piping and for making baths.[5] In medieval times anyone who worked with lead was referred to as a plumber as can be seen from an extract of workmen fixing a roof in Westminster Palace and were referred to as plumbers "To Gilbert de Westminster, plumber, working about the roof of the pantry of the little hall, covering it with lead, and about various defects in the roof of the little hall".[6] Thus a person with expertise in working with lead was first known as a Plumbarius which was later shortened to plumber.
×