Drain snake. This is a simple, shorter version of the big gas-powered snake that plumbers use to clear clogs deep in your drains. But if the clog is not so deep, owning one of these can save you a good bit of money. They come in different lengths and you can buy powered versions, but a simple 25' snake with a hand-powered crank will set you back less than $25.
Two-handle faucets are most often found in the bathroom, but you see them in some kitchens. Two-handle faucets use three types of mechanisms. The first two are the same as two of the mechanisms used in a single-handle faucet: cartridge and ceramic disc. The third type is a compression (or reverse-compression) mechanism. Compression faucets are the simplest type, using rubber washers that get compressed against one another to seal the valve. They do tend to wear out faster than other faucet types, but are also least expensive to repair.
The projects we've laid out here are particularly simple, but plumbing can be tricky, so if you're ever unsure, don't be afraid to ask for help. These projects are all pretty straightforward, but you never know what will come up, especially with older homes. We've selected some pretty good videos, but do some research and find some other videos if something about your setup looks a little different. The Internet is a wonderful thing.
Even attempting to fix your plumbing problems on your own without proper knowledge can cause massive problems down the line. Book your plumber using the Handy platform and you’ll be matched with professionals who know just what they’re doing. Experienced and practiced in their craft, they’ll provide you with the best job at a price that won’t break the bank. When you use Handy to find plumbing services, you can rest assured that you’ll be connected with a capable plumbing expert who will get your job done without being a pain in the wallet.
Think that by calling for plumbing services you will have to clean up after the work is done? Not when you work with us! At Bud’s Plumbing & Repair Service, our uniformed plumbers arrive at your door with shoe covers and are conscious of the cleanliness of the work area. In fact, once the job is done, you won’t be able to tell we were even there! That’s how clean we leave your property. There is no mess for you to clean up, so you can get back to your normal routine without hassle.
Because your plumbing system is so important, our Oahu plumber is honored by the fact local residents and businesses have trusted us with all of their plumbing needs for over three decades. We believe that we have been so successful because in every project we undertake we strive to honor the trust Oahu has shown in us by putting our best effort forward to provide the highest quality plumbing services. Our Oahu plumber would be excited to continue this tradition of excellence with during your next plumbing project.
We've talked before about home electrical projects you can handle on your own and now it's time to tackle plumbing. The projects we're covering here mostly deal with repairing things like running toilets and leaky faucets, and replacing fixtures like faucets and shower heads. These are beginner-level projects that are fairly easy to do and can save you a lot of money if you tackle them yourself.
If you have a major fix in your home, it’s important to shop around for a plumber to do the work. At least three bids will help you determine the range of the project, so you can weigh the pros and cons of price and the reputation of the plumbers. Get references and contact them. Also, a good plumber isn’t likely to nickel and dime you. For the smaller jobs, check out these 11 plumbing tricks.
The straight sections of plumbing systems are called "pipes" or "tubes". A pipe is typically formed via casting or welding, whereas a tube is made through extrusion. Pipe normally has thicker walls and may be threaded or welded, while tubing is thinner-walled and requires special joining techniques such as brazing, compression fitting, crimping, or for plastics, solvent welding. These joining techniques are discussed in more detail in the piping and plumbing fittings article.
It’s a family event in late October when many American households carve a pumpkin into a Halloween jack-o-lantern. The kids delight in the whole process, especially when mom and dad let junior scoop the pumpkin pulp out of the pumpkin. But what happens next is the scary part. Often, those slimy pumpkin guts are pushed down the sink drain then the disposal is turned on to chop it into tiny bits before the water washes it away. Except, it doesn’t quite ... Read More >
Call Steve’s Plumbing Service today if you need to hire a plumber in Oahu. Our courteous and polite staff would be happy to assist you in any way that we can. We will answer all of your plumbing related questions and provide you with further detail about all of our amazing plumbing services. Our team would be extremely excited to schedule your plumbing appointment today or at your earliest convenience.
This information is not intended as an offer to sell, or the solicitation of an offer to buy, a franchise. It is for information purposes only. Read More Currently, the following states regulate the offer and sale of franchises: California, Hawaii, Illinois, Indiana, Maryland, Michigan, Minnesota, New York, North Dakota, Oregon, Rhode Island, South Dakota, Virginia, Washington, and Wisconsin. If you are a resident of or want to locate a franchise in one of these states, we will not offer you a franchise unless and until we have complied with applicable pre-sale registration and disclosure requirements in your state. Read Less Mr. Rooter is a registered trademark of Mr. Rooter LLC Copyright © 2017 Mr. Rooter, All rights reserved. All Mr. Rooter Plumbing Franchise Locations Are Independently Owned And Operated.
Get a minimum of three bids. Estimates for an average-sized job should be within a few hundred dollars. Be suspicious of anything that is substantially lower or double the price of the rest, and watch out for hidden fees, like charges for travel expenses. They could be signs of a home improvement scam. A good plumber will not nickel and dime you like this, and many of us will offer free estimates.
Also, you might run into a problem where the shower arm is too short or angled too sharply for the shower head you bought. This can happen more with the wand-type shower heads and the wall gets in the way of the wand. You can solve this problem by making sure you buy a shower head that fits or installing an extension arm onto the main shower arm. You can find those the same place you buy the shower heads.
“Don’t go to the Yellow Pages to find a plumber,” says Berkey’s Bill Stevens. “It’s like guessing lottery numbers. Anyone can make an appealing ad, but that doesn’t mean they are legitimate. In this industry, it’s easy for a plumber who develops a poor reputation to advertise under a different name. They come and go.” Even searching for someone online may end up being a scam using fake reviews. Instead, look for a plumber who is well-established in your community. Check the Better Business Bureau and read customer reviews at sites such as HomeAdvisor, Angie’s List, or Citysearch. Local contractors or plumbing fixture stores can also refer you to a quality plumber, according to Grady Daniel, who owns a plumbing company in Austin, Texas. “Most of these firms won’t work with bad plumbers.” Or simply ask your neighbors for a referral. A trusted plumber that consistently delivers quality service does not remain a secret for very long.
Accurate Leak & Line is specialized in the complete slab leak detection of sub-slab residential or commercial water and sewer piping systems. A combination of the best re-piping and Nu Flow relining repair options is offered to residential customers throughout the state. This wide variety of trenchless or traditional solutions allows our clientele to make the best decisions for their home and their pocketbook. Quality workmanship is always provided in a timely manner on all of our residential jobs, big or small.
Alexa is an experienced lifestyle and news writer, currently working with Reader's Digest, Shape Magazine, and various other publications. She loves writing about her travels, health, wellness, home decor, food and drink, fashion, beauty, and scientific news. Follow her traveling adventures on Instagram: @living_by_lex, send her a message: [email protected], and check out her website: livingbylex.com
For the highest quality, expertise and excellent customer service you seek for all your plumbing repairs and plumbing installation needs, contact Baker Brothers Plumbing, Air Conditioning & Electrical at 214-324-8811214-324-8811 to schedule an appointment. Our licensed Dallas Plumbing technicians are background checked and drug-screened, ready to provide you with the best possible service in the DFW metroplex.
Hello, long story. Toilet line stopped up two years ago. A company used high pressure water to clean line. Didnt work. Came back a second time with a plummer. Spouse was told that the line had collapsed, filled with rocks or tiles. Plummer then disconnected that line put in a second line, punched a hole in my tank, fed the new line in that hole. Now two years later, each heavy rain brings a strong sewer smell into the house. Found out later that there were no rocks or tiles in original line, only a large calcium build up over 25 years that had clogged the original line. I do not know if when the new line was put in, the old line was closed properly or if either line was or should be vented? I would like the original line reconnected and the newer line just removed. I plan then to repair the hole in septic tank where the new line entered with tar or concete. I need someone to fix my smelly home.
For many centuries, lead was the favoured material for water pipes, because its malleability made it practical to work into the desired shape. (Such use was so common that the word "plumbing" derives from plumbum, the Latin word for lead.) This was a source of lead-related health problems in the years before the health hazards of ingesting lead were fully understood; among these were stillbirths and high rates of infant mortality. Lead water pipes were still widely used in the early 20th century, and remain in many households. In addition, lead-tin alloy solder was commonly used to join copper pipes, but modern practice uses tin-antimony alloy solder instead, in order to eliminate lead hazards.