Most plumbers wont mess with the septic tank. We deal mostly with components inside the house. Did you have a vent pipe in the yard (often looks like a candy cane made of PVC) before the repair but not after? If all he did was replace the line it shouldn't cause a smell inside the house. All plumbing fixtures inside the house should have properly functioning traps. Those traps would create and maintain a water seal against the sewer gases. You should have at least one vent through the roof to equalize pressures within the drainage system. This prevents positive pressures within the system (caused by fixtures discharging into the lines, ie toilet flush) from pushing gas out through the traps, and negative pressures (the waste in line will pull air behind it like your finger over the end of a straw) from sucking water out of the traps.
I thought that my sump pump had ended its life and needed to be replaced. The contractor I found through Home Adviser came out the following day and arrived reasonably promptly. The technician tested the pump and it wasn't responding. He then checked the breaker panel and all seemed well. However he checked to see if power was reaching the outlet, it wasn't so he tripped some breakers and reset them and the power to my pump came on and the pump works so a replacement wasn't necessary. He charged $75.00 which I think was reasonable for a call-out fee and time spent.
I had another lady who said she wanted to run to the grocery store to get some coffee to make for me and my guys while we were installing her new kitchen. She said she was just gonna run to the store and asked if we wouldn’t mind keeping an eye out for her one-year-old daughter who was sleeping at the time. We said fine, but she ended up not returning until four hours later. The kid was screaming her head off and we didn’t know what to do. We tried holding her. We didn’t know if she was hungry or what to feed her. She just kept crying.
Steve Huffman of Steve's Plumbing Service has made more than one service call to my house. Each time I have been more than pleased with his job. He responds relatively soon to a call. He is a fast and neat worker, at the same time a very efficient and neat worker. He never leaves a mess but cleans up thoroughly when the job is finished. His prices are very reasonable. I do not hesitate to recommend him to my family and close friends.
With all the freezing weather our city has had, my dad had a problem with his water pipes and I told him to call BL plumbing service. From the first phone call he made, the company gave him the most remarkable customer service. The dispatcher promptly made an appointment for him and within a couple of hours 2 workers were at his home working on the problem and fixing his pipes! The workers were very kind, helpful and extremely courteous to my dad. Not only was the work done quickly, but also, the cost of the repair was more than fair. I am so grateful for the service that was given to my dad and I will highly recommend this company to anyone needing plumbing work.
We've talked before about home electrical projects you can handle on your own and now it's time to tackle plumbing. The projects we're covering here mostly deal with repairing things like running toilets and leaky faucets, and replacing fixtures like faucets and shower heads. These are beginner-level projects that are fairly easy to do and can save you a lot of money if you tackle them yourself.
Clogged drains are no fun. We've shown you several ways to clear a clogged drain and how to clear a blocked P-trap under a sink, but bathtub drains can be a little more challenging. A lot more hair and other gunk goes down them than you think. Add to this the fact that most bathtub drains take a 90-degree turn that makes getting a drain snake down them more difficult.
We strive in delivering top quality service to all of our customers. We want you happy and satisfied by the time we walk out your door. We will help locate your issue with a free estimate. Explain what the problem is and offer you our service to fix the problem. You are not obligated to use us. We treat each customer friendly, professional and courtesy.
We contacted Best Plumbing Service of Cincinnati to have the sump pump and the outlet pipes checked as our basement flooded recently and we were not sure whether the sump pump malfunctioned or the outlet pipe was blocked. Both plumbers did a fantastic job looking over the system, diagnosing, and fixing the problem. They were extremely honest, courteous , and professional. We are very pleased with their outstanding service and would very highly recommend Best Plumbing Service of Cincinnati. M Effat
For the highest quality, expertise and excellent customer service you seek for all your plumbing repairs and plumbing installation needs, contact Baker Brothers Plumbing, Air Conditioning & Electrical at 214-324-8811214-324-8811 to schedule an appointment. Our licensed Dallas Plumbing technicians are background checked and drug-screened, ready to provide you with the best possible service in the DFW metroplex.
Galvanized steel potable water supply and distribution pipes are commonly found with nominal pipe sizes from 3⁄8 inch (9.5 mm) to 2 inches (51 mm). It is rarely used today for new construction residential plumbing. Steel pipe has National Pipe Thread (NPT) standard tapered male threads, which connect with female tapered threads on elbows, tees, couplers, valves, and other fittings. Galvanized steel (often known simply as "galv" or "iron" in the plumbing trade) is relatively expensive, and difficult to work with due to weight and requirement of a pipe threader. It remains in common use for repair of existing "galv" systems and to satisfy building code non-combustibility requirements typically found in hotels, apartment buildings and other commercial applications. It is also extremely durable and resistant to mechanical abuse. Black lacquered steel pipe is the most widely used pipe material for fire sprinklers and natural gas.
Having the right tools can mean the difference between a quick project and a complete mess. Fortunately, you won't need too much to handle the projects here and what you will need is pretty inexpensive (certainly less expensive than hiring a plumber). You can get everything on this list for about $100, and you won't need it all unless you're doing all the projects. Where I live, that's about the cost of hiring a plumber for an hour.
Before you get involved with most plumbing projects, you'll need to shut off the water flowing to whatever you're working on. Most of the time, there are easy-to-access gate valves or compression valves that you can turn with your hand. Turn them clockwise all the way to turn off the water and counter-clockwise to turn it back on when you're done. For sinks, look under the sink and you'll usually see two valves—one for hot water and one for cold. On kitchen sinks, you might also see valves for the ice maker on your fridge or your dishwasher. Just turn them all off. For toilets, the valves are on the wall or right on the pipe behind the toilet.
Wall thickness does not affect pipe or tubing size. 1/2" L copper has the same outer diameter as 1/2" K or M copper. The same applies to pipe schedules. As a result, a slight increase in pressure losses is realized due to a decrease in flowpath as wall thickness is increased. In other words, 1 foot of 1/2" L copper has slightly less volume than 1 foot of 1/2 M copper.
Alejandro is the best, most versatile plumber I have ever used. When I needed a new toilet installed in a guest bedroom, he also did a great job replacing the the damaged tile work around the base of the old toilet. When I had new countertops installed in my kitchen, he came up with a creative solution to a problem I had with the old gas line running to my stove-top. He is not expensive, a nice guy and a true professional.
If left unfixed, a running toilet or a leaky faucet can end up costing you hundreds of dollars. Check out your water bill and how your water is running. If you find your kitchen dripping non-stop and your water bill going higher, you may have a leak! Let Parker & Sons put a stop to those leaks. Our team of expert plumbers will make sure to get the work done faster, get it right the first time, and do it efficiently.
JAG PLUMBING PRODUCTS is very pleased to partner JAG PLUMBING PRODUCTS is very pleased to partner with BRIGGS Plumbing Products USA to act as the direct distributor of the prestigious BRIGGS and Sayco Brand line of Repair Parts. This 2-pack of Toilet tank flappers are the exact replacement required to fix your BRIGGS Toilet. JAG PLUMBING PRODUCTS strives ... More + Product Details Close
The easy to install reinforced Wax Toilet Bowl The easy to install reinforced Wax Toilet Bowl Gasket features a polyethylene flange for floor and wall bowls. Packaged in a plastic sleeve in order to maintain its shape. Accommodates 3 in. and 4 in. waste lines (sold separately). Includes a 1/4 in. x 2-1/4 in. E-Z Snap brass bolt ... More + Product Details Close
Even attempting to fix your plumbing problems on your own without proper knowledge can cause massive problems down the line. Book your plumber using the Handy platform and you’ll be matched with professionals who know just what they’re doing. Experienced and practiced in their craft, they’ll provide you with the best job at a price that won’t break the bank. When you use Handy to find plumbing services, you can rest assured that you’ll be connected with a capable plumbing expert who will get your job done without being a pain in the wallet.
Hello! My name is Lorinn and I am 26 years old. I have been working in different construction trades for 8+ years now. To name a few I am a skilled in flooring, cabinets/closets, and electrical(fans, fixtures, etc). I’ve gotten as experienced as I am because I genuinely enjoy working with my hands and learning new things. I take pride in my work, and love exceeding peoples expectations.
My plumbing experience was to have the plumbing disconnected under the sink so the counter top and new sink could be installed. I thought the service of $115 was high, but usually if there is an additional fees, it is usually rolled into the cost of repairs or labor. This company also charged 3.75 % for putting it on a credit card, which was not mentioned until I received the invoice in the mail after paying on the phone.
I had called Ben Franklin to fix a pin hole leak in the meter horn. Booking an appointment was very easy and the crew (Sid and Brandon) showed up on time. They quickly found out that a stop valve was not working and had to be replaced as well. Sid clearly explained my options and the charges upfront. He dealt with the city for water shut off, went about the job in a quick and efficient manner. Sid was very professional and explained clearly what he was doing. He patiently answered all my questions. Brandon was very practical and frank. As they were finishing up (I had to leave the house for an hour) they spotted a leak in another valve and fixed that also. I thought it was highly ethical of them to do so. Thank you Sid and Brandon!