Drain snake. This is a simple, shorter version of the big gas-powered snake that plumbers use to clear clogs deep in your drains. But if the clog is not so deep, owning one of these can save you a good bit of money. They come in different lengths and you can buy powered versions, but a simple 25' snake with a hand-powered crank will set you back less than $25.
Wooden pipes were used in London and elsewhere during the 16th and 17th centuries. The pipes were hollowed-out logs, which were tapered at the end with a small hole in which the water would pass through. The multiple pipes were then sealed together with hot animal fat. They were often used in Montreal and Boston in the 1800s, and built-up wooden tubes were widely used in the USA during the 20th century. These pipes, used in place of corrugated iron or reinforced concrete pipes, were made of sections cut from short lengths of wood. Locking of adjacent rings with hardwood dowel pins produced a flexible structure. About 100,000 feet of these wooden pipes were installed during WW2 in drainage culverts, storm sewers and conduits, under highways and at army camps, naval stations, airfields and ordnance plants.
Cast iron and ductile iron pipe was long a lower-cost alternative to copper, before the advent of durable plastic materials but special non-conductive fittings must be used where transitions are to be made to other metallic pipes, except for terminal fittings, in order to avoid corrosion owing to electrochemical reactions between dissimilar metals (see galvanic cell).
It’s a family event in late October when many American households carve a pumpkin into a Halloween jack-o-lantern. The kids delight in the whole process, especially when mom and dad let junior scoop the pumpkin pulp out of the pumpkin. But what happens next is the scary part. Often, those slimy pumpkin guts are pushed down the sink drain then the disposal is turned on to chop it into tiny bits before the water washes it away. Except, it doesn’t quite ... Read More >
Most large cities today pipe solid wastes to sewage treatment plants in order to separate and partially purify the water, before emptying into streams or other bodies of water. For potable water use, galvanized iron piping was commonplace in the United States from the late 1800s until around 1960. After that period, copper piping took over, first soft copper with flared fittings, then with rigid copper tubing utilizing soldered fittings.