Wooden pipes were used in London and elsewhere during the 16th and 17th centuries. The pipes were hollowed-out logs, which were tapered at the end with a small hole in which the water would pass through. The multiple pipes were then sealed together with hot animal fat. They were often used in Montreal and Boston in the 1800s, and built-up wooden tubes were widely used in the USA during the 20th century. These pipes, used in place of corrugated iron or reinforced concrete pipes, were made of sections cut from short lengths of wood. Locking of adjacent rings with hardwood dowel pins produced a flexible structure. About 100,000 feet of these wooden pipes were installed during WW2 in drainage culverts, storm sewers and conduits, under highways and at army camps, naval stations, airfields and ordnance plants.
Hello, long story. Toilet line stopped up two years ago. A company used high pressure water to clean line. Didnt work. Came back a second time with a plummer. Spouse was told that the line had collapsed, filled with rocks or tiles. Plummer then disconnected that line put in a second line, punched a hole in my tank, fed the new line in that hole. Now two years later, each heavy rain brings a strong sewer smell into the house. Found out later that there were no rocks or tiles in original line, only a large calcium build up over 25 years that had clogged the original line. I do not know if when the new line was put in, the old line was closed properly or if either line was or should be vented? I would like the original line reconnected and the newer line just removed. I plan then to repair the hole in septic tank where the new line entered with tar or concete. I need someone to fix my smelly home.
I used Go Green Express Home Services for a minor plastic pipe repair under my kitchen sink...The worker did a great job fixing this minor pipe plastic pipe repair( my original pipe was too short and he needed to extended the pipe and then reconnect). It took him less than 10 minutes to fix. I was first quoted $125 +tax but when the worker went to his truck and spoke to whoever he spoke to at the office, the price rose to $155.10 +tax for a total of $167.10...I thought that was a little too high. Will I use this company again, I Don't Know. It would be helpful if they would have a set price list for jobs (minor repairs, Major repairs etc...), then you as the consumer can see beforehand what the cost maybe and work from there with the company. Minor repairs, Major repairs this company should at least have a set-price list. ..The worker was great and efficient and did a good job on the repair but their prices are a bit costly. And yes, I did write this in their review.
“Don’t assume that every Mr. Fix-it advertising his services in the local Pennysaver or on Craigslist is a licensed plumber,” says one New York plumber. There is no national standard for issuing licenses. Some plumbers are licensed by the state, others by the counties they work in. Check with your local city hall or chamber of commerce. They should be able to direct you to the appropriate source for a list of licensed plumbers in your area.
Sometimes, a repair job isn’t quite enough. When this happens, we offer expert plumbing installation services from our professional plumbing contractors. We strive to offer customers high-quality water heater installation service, water heater replacement, home water filtration installation, and more. We always suggest the most cost-effective repair or installation options to make sure that our solution meets your needs and your budget.
No plumber is going to come right out and explain that they don’t have the required license to work for you. So if you know someone who is a great plumber, but they don’t have a license, hire them at your own risk. Licensed plumbers know the local building codes and regulations, have completed a certain amount of hours on the job and are insured. Want to become a master plumber yourself? Here are 28 tips.
Galvanized steel potable water supply and distribution pipes are commonly found with nominal pipe sizes from 3⁄8 inch (9.5 mm) to 2 inches (51 mm). It is rarely used today for new construction residential plumbing. Steel pipe has National Pipe Thread (NPT) standard tapered male threads, which connect with female tapered threads on elbows, tees, couplers, valves, and other fittings. Galvanized steel (often known simply as "galv" or "iron" in the plumbing trade) is relatively expensive, and difficult to work with due to weight and requirement of a pipe threader. It remains in common use for repair of existing "galv" systems and to satisfy building code non-combustibility requirements typically found in hotels, apartment buildings and other commercial applications. It is also extremely durable and resistant to mechanical abuse. Black lacquered steel pipe is the most widely used pipe material for fire sprinklers and natural gas.
I had 207 Plumbing come to fix a leak in my ceiling. It's a terrible, terrible company to do business with. He came and fixed a broken pipe in the ceiling, and I asked him to check the rest of the pipe to make sure that nothing else was broken, he said everything was OK and charged me $219.00 for 45 minutes and left. Never cleaned up his mess. I went to clean up the mess after he left and found there was more damage to the pipe. I called him to come back, which he did. He looked at the water coming down from the ceiling, into a light fixture and said he had another job to go to and couldn't come back until next week. He also wanted to charge me $350.00 to come back. I told him that was too much and he said he would make an exception and only charge me $219.00. Now I have major damage done to the ceiling, the light fixture and the floor. All of this could have been prevented if he had stayed and fixed the problem. I will NOT hire him again.
"We have found our plumber for life! Jim is awesome! We just bought a house with a leak in the foundation, and in spite of the complicated and extensive nature of the repairs needed, Jim quoted us an incredibly reasonable price. Having just closed on a house, though, we were extremely short on funds, and so to help us out, Jim did a temporary fix for much less, and even though he was going above and beyond and doing this extra work for us, he said he'd even deduct the cost of that repair from the total of the final, permanent repair, when we had that done!! I can't say enough good things about him - there's much more, but I don't have room!"
Wall thickness does not affect pipe or tubing size. 1/2" L copper has the same outer diameter as 1/2" K or M copper. The same applies to pipe schedules. As a result, a slight increase in pressure losses is realized due to a decrease in flowpath as wall thickness is increased. In other words, 1 foot of 1/2" L copper has slightly less volume than 1 foot of 1/2 M copper.
If nothing inside the home was altered you should not be getting a smell. Personally I'm confused as to why the repair person would have left the original line there and ran another one through a new hole. I would have pulled the old line up, ran the new line (in PVC) and used the same hole in the septic tank instead of creating a new one. Did he seal up the hole in the tank from the old line?
Premier level plumbing solutions are right in your neighborhood. Bud’s Plumbing & Repair Service is your local Evansville, IN plumber specializing in full-service solutions at honest, upfront prices. In fact, we are the only plumbing company in the area offering upfront pricing. This means no surprises at the end! Want to see what your neighbors think of our services? Click here to read their reviews.
Master plumbers on construction jobs may be involved with developing blueprints that show the placement of all the pipes and fixtures. Their input helps ensure that a structure’s plumbing meets building codes, stays within budget, and works well with the location of other features, such as electric wires. Many diagrams are now created digitally with the use of Building Information Modeling (BIM), which allows a building’s physical systems to be planned and coordinated across occupations.
Curtis did an excellent job in identifying the problem and providing a couple solutions. We discussed both and came to a mutual agreement, rather than him explicitly saying this is the only option and charge excessive amount. Curtis was very easy to talk to; even though I had lots of questions he was very professional throughout. He was prompt to the appointment, although I forgot about the time, he reached out and waited until I arrive. I would highly recommend their services for your plumbing needs!
Leaky faucets are more than just a minor inconvenience. All that dripping water can corrode your sink and drain basins, wear away at your pipes and waste hundreds of gallons per year! Don’t let this happen to you – call our friendly Baltimore, Washington D.C., Northern Virginia, Delaware and the Philadelphia plumbing technicians for faucet repair today!
I think it is rather rude and a bit dishonest for people to not divulge their total fees upfront, an of course we should know to ask. But the normal person wouldn't know the questions to ask until they are burnt once like this, and then there still could be costs for walking up stairs or charge another service call if they need to go somewhere to use the bathroom and come back. THAT ISN'T A QUESTION I WOULD THINK TO ASK.
Cast iron and ductile iron pipe was long a lower-cost alternative to copper, before the advent of durable plastic materials but special non-conductive fittings must be used where transitions are to be made to other metallic pipes, except for terminal fittings, in order to avoid corrosion owing to electrochemical reactions between dissimilar metals (see galvanic cell).