Let's start with the easiest possible project: Installing a new shower head is as simple as it gets. Typically, all you have to do is unscrew the old shower head from the shower arm (the pipe coming out of the wall), clean off the threads on the shower arm and wrap a bit of Teflon tape around it, then screw on the new shower head. It's really that simple (and if you don't believe me, check out the video above from Dummies.com). Do read the installation instructions on the shower head you buy, though. Some are designed not to require Teflon tape and can actually leak if you use it.
I just had my pipe under the sink unclogged and new pipes put in $600.00, then they flushed out the pipe from under the sink to the outside pipe $700.00, Total of $1.600.00, I thought that the price was high, I got the plumber from Home Advisors, not sure they had to do all they did but they said I needed the work done. The same evening hike using the dishwasher I had a leak in one of the pipes they put in, they came back the next day to fix it. Don't know if I will use them again.. They were K&D kitchens.
The straight sections of plumbing systems are called "pipes" or "tubes". A pipe is typically formed via casting or welding, whereas a tube is made through extrusion. Pipe normally has thicker walls and may be threaded or welded, while tubing is thinner-walled and requires special joining techniques such as brazing, compression fitting, crimping, or for plastics, solvent welding. These joining techniques are discussed in more detail in the piping and plumbing fittings article.
I called BL Plumbing when a small leak started coming out of my shower. They responded quickly and Billy arrived in the afternoon. He diagnosed the problem and proposed a solution including cost. I approved and he went straight to work. Within the hour, the problem was resolved. Billy recommended work that was needed to reduce water pressure for the entire house. I approved the work including cost and Billy had that problem fixed quickly and efficiently. A small leak in the pipe below the shower led to a much needed home improvement. As we finished, Billy and I discussed potential future work and issues regarding maintenance concerning the overall projects completed that day. The entire process was a very positive experience.
“Don’t assume that every Mr. Fix-it advertising his services in the local Pennysaver or on Craigslist is a licensed plumber,” says one New York plumber. There is no national standard for issuing licenses. Some plumbers are licensed by the state, others by the counties they work in. Check with your local city hall or chamber of commerce. They should be able to direct you to the appropriate source for a list of licensed plumbers in your area.
CON'T FROM COMMENTS EARLIER. However, the installation took less than 3/4/ hour and was a basic regulator with no other function. Looking up the price afterwards, invoice did not list type or price, it appears that it would have cost me around $60 for the regulator and another $15 or so for the additional supplies necessary to install it and it was really a rather simple job with easy access. Given that, it seems that $300 for less that an hours worth of on site work, company says it does not include commute time in its prices, is a little high. While flat rate quotes are nice, they must take into consideration situations where the work load differs depending on the circumstances. Therefore, unless you are at the upper end of the harder work needed than the average job. it can be argued that my estimated price of $300 for labor was more than a little high. Maybe I am wrong since I have not used their services for years and am not knowledgeable of the costs of equipment and professional labor today.
“I have used Central Penn for many repairs/installs over the last 15 years. They have always responded in a prompt manner and I found their people to be very friendly, efficient and competent in diagnosing and repairing any issues I had, whether related to plumbing or HVAC. Furthermore, which you can’t take for granted these days, the guys are very respectful of your home and are careful in their work and thoroughly clean up after the job is completed.”
The word "plumber" dates from the Roman Empire. The Latin for lead is plumbum. Roman roofs used lead in conduits and drain pipes and some were also covered with lead, lead was also used for piping and for making baths. In medieval times anyone who worked with lead was referred to as a plumber as can be seen from an extract of workmen fixing a roof in Westminster Palace and were referred to as plumbers "To Gilbert de Westminster, plumber, working about the roof of the pantry of the little hall, covering it with lead, and about various defects in the roof of the little hall". Thus a person with expertise in working with lead was first known as a Plumbarius which was later shortened to plumber.