Pro Plumbers

I had 207 Plumbing come to fix a leak in my ceiling.  It's a terrible, terrible company to do business with.  He came and fixed a broken pipe in the ceiling, and I asked him to check the rest of the pipe to make sure that nothing else was broken, he said everything was OK and charged me $219.00 for 45 minutes and left.  Never cleaned up his mess.  I went to clean up the mess after he left and found there was more damage to the pipe.  I called him to come back, which he did.  He looked at the water coming down from the ceiling, into a light fixture and said he had another job to go to and couldn't come back until next week.  He also wanted to charge me $350.00 to come back.  I told him that was too much and he said he would make an exception and only charge me $219.00.  Now I have major damage done to the ceiling, the light fixture and the floor.  All of this could have been prevented if he had stayed and fixed the problem.  I will NOT hire him again.

Our sewer repair and replacement experts service Baltimore, Washington D.C., Northern Virginia, Delaware and the Philadelphia Area.  The specific counties we service are:  Baltimore County, Howard County, Montgomery County, Prince Georges County, Anne Arundel County, Harford County, Carroll County, Fairfax, New Castle County, Delaware County, Chester County, Stafford County, Fredericksburg County, Fairfax City, Alexandria, Arlington County, Loudon County, Prince William County, Falls Church, Manassas and Cecil County.
Some allege that putting a brick in the toilet tank can save water, but doing that can keep your toilet from flushing correctly. Another plumbing tip, avoid liquid drain cleaners. Liquid drain cleaners are also bad news—they eat away at the pipes. Try a plunger or, better yet, a $30 auger. Don’t have either? Here’s how to unclog a toilet without a plunger.
I have no problem paying for any service I receive but when Allied Reddi-Rooter came into my home and immediately tell me and them tell me it would cost me 350.00 for them to install a new Rheem water heater (his recommendation) that cost 409.00 I have a problem. If the cost is exactly how Home Advisor indicates then he’s charging 350.00an hour.  I did my homework checked with other plumbers and it. Would not take an hour to remove old and install the new water heater. Thank Goodness I did my research won’t be using their services and I will be letting others know what happen to me. Shame on you Allied
When you need honest, reliable plumbing, heating, or cooling services in Northern Virginia, suburban Maryland, or throughout the D.C. area, look no further than My Plumber Heating and Cooling! We’re proud to be the region’s number one choice for home comfort since 1982. Whether you’re dealing with a broken air conditioner, outdated heating system, backed-up drain, or burst pipe, our highly trained team is ready to help. We offer everything from emergency plumbing repairs to new heating and air conditioning system installation to indoor air quality services and more. Most of all, we stand behind everything we do with extensive warranties and our 100% customer satisfaction guarantee. At My Plumber Heating and Cooling, your comfort is our priority! We have three convenient locations in Manassas, Fairfax, and Fredericksburg so that you don't have to wait to get the help you need.
I had called Ben Franklin to fix a pin hole leak in the meter horn. Booking an appointment was very easy and the crew (Sid and Brandon) showed up on time. They quickly found out that a stop valve was not working and had to be replaced as well. Sid clearly explained my options and the charges upfront. He dealt with the city for water shut off, went about the job in a quick and efficient manner. Sid was very professional and explained clearly what he was doing. He patiently answered all my questions. Brandon was very practical and frank. As they were finishing up (I had to leave the house for an hour) they spotted a leak in another valve and fixed that also. I thought it was highly ethical of them to do so. Thank you Sid and Brandon!
Hello I had a plumber do an estimate for me to replace our copper pipes with plastic as we have no existing walls up in our basement yet...pretty basic job... so we figured we could upgrade as we do live in Northern Ontario and it does tend to get quite cold here in the winters.  We dont have any existing problems with our plumbing right now just figured it would be good time to do the job and perhaps change the pipes to 3 quarter inch for faster flow.  Well I never thought in all my life I would get an estimate back that would state $350.00 an hour in labor...yes that is correct $350.00 an hour...estimated 10 hours for the job to be completed.  So he quoted me $3500.00 for labor alone.. not supplies?  Well needless to say I will be happy with my half inch copper pipes and will happily wait for my bathtub to fill up at a slower pace.  Just wanted to know what your thoughts are on this $350.00 an hour quote?  Thank you and enjoy your day.
Curtis did an excellent job in identifying the problem and providing a couple solutions. We discussed both and came to a mutual agreement, rather than him explicitly saying this is the only option and charge excessive amount. Curtis was very easy to talk to; even though I had lots of questions he was very professional throughout. He was prompt to the appointment, although I forgot about the time, he reached out and waited until I arrive. I would highly recommend their services for your plumbing needs!

When you need plumbing or HVAC services in Castle Rock, there’s only one choice to make: PRO Plumbing Service. With more than 2500 service calls per year, we are your trusted plumbing, heating, and air conditioning company. If you are looking for a family-owned and operated plumbing and HVAC company, our top-rated HVAC contractors and plumbers ready to assist.
For commercial plumbing services, we provide you with ejector pump service, sump pump services and major water line repair and copper line replacement. These are just some of the services that we offer you. If you are looking for an emergency plumbing service, we can definitely assist you as well with this. Contact us today and speak with one of our reps to see how we can help you transform your remodeling at your home to something that you will be happy with. Also providing you with excellent services and excellent competitive pricing for all your plumbing needs in Atlanta and the surrounding areas.
Help! The toilet won’t stop running. It’s a bummer, sure, but it’s something you don’t need to call your plumber about. In fact, DIYers should take note that it’s a quick fix that will cost you just $5. For instance, your handle might just be sticking, which can be solved by spraying some lubricant where the handle meets the porcelain. Ready to DIY? Here’s how to fix a running toilet.
When you need plumbing repair our plumbers will be at you residence quickly if you live in Zip Codes 75050, 75051, 75052, 75053, 75054, which we serve. There are many reasons you would need a good plumber. Your toilet might be backed up or your sewer may be overflowing. Whether you need help to repair leaks in the kitchen, bathroom or shower, our plumbing service is one of the fastest in town and one that most people call if they need help quickly. Easy accessibility is critical when you need help urgently, which could happen for example if you have a serious water leak, or sewage backup.
Todd did an amazing job, and fixed a problem that could of been devastating. Replacing a leaking water heater and also a replacing a failing, leaking main shut of valve. The possibility of major flooding was a real danger It was a 12 unit townhome which made the job even trickier, as water had to be shut off to the entire building while he fixed the valve. Todd, replaced them quickly and expertly, without a hitch. Plumbing repairs are never fun for a homeowner, but these people (especially Todd) do great work. It is definitely a weight lifted off my chest.
Two-handle faucets are most often found in the bathroom, but you see them in some kitchens. Two-handle faucets use three types of mechanisms. The first two are the same as two of the mechanisms used in a single-handle faucet: cartridge and ceramic disc. The third type is a compression (or reverse-compression) mechanism. Compression faucets are the simplest type, using rubber washers that get compressed against one another to seal the valve. They do tend to wear out faster than other faucet types, but are also least expensive to repair.
While you might be tempted to get out your wrench and try and fix those plumbing fixtures, plumbing can be a lot more complicated than you might think. In the wrong hands, even the simplest-seeming of plumbing jobs can quickly become something disastrous or costly. The chances are that, whatever your problem is, your plumber has seen it before and will be able to rectify the situation, quickly and efficiently. Why run the risk of turning a simple job into a plumbing catastrophe, when you can book plumbing services through Handy to nip it in the bud?

For details about apprenticeship or other opportunities in this occupation, contact the offices of the state employment service; the state apprenticeship agency; local plumbing, heating, and cooling contractors or firms that employ fitters; or local union–management apprenticeship committees. Apprenticeship information is available from the U.S. Department of Labor's Apprenticeship program online, or by phone at 877-872-5627.

"Bacon Plumbing sent their plumber Ryan to advice me on how to fix my problem. He was very through unlike other companies I talked to.. He gave me several plans of how to repair the problem and what the cost was, and the how he would do it if it was his home. He insisted on a city inpect permit and city passed it first time If Bacon Plumbling losing him, they will lose an asset. "

As a family-owned and operated company, we pride ourselves on putting our customers’ satisfaction at the forefront of our services. Everything we do, from beginning to end, is designed to provide optimal customer service. With over 20 years of service, there is a reason the Fort Worth and Azle communities trust us with all their home plumbing projects. Allow us to show you why we are the best.
“Don’t go to the Yellow Pages to find a plumber,” says Berkey’s Bill Stevens. “It’s like guessing lottery numbers. Anyone can make an appealing ad, but that doesn’t mean they are legitimate. In this industry, it’s easy for a plumber who develops a poor reputation to advertise under a different name. They come and go.” Even searching for someone online may end up being a scam using fake reviews. Instead, look for a plumber who is well-established in your community. Check the Better Business Bureau and read customer reviews at sites such as HomeAdvisor, Angie’s List, or Citysearch. Local contractors or plumbing fixture stores can also refer you to a quality plumber, according to Grady Daniel, who owns a plumbing company in Austin, Texas. “Most of these firms won’t work with bad plumbers.” Or simply ask your neighbors for a referral. A trusted plumber that consistently delivers quality service does not remain a secret for very long.
If left unfixed, a running toilet or a leaky faucet can end up costing you hundreds of dollars. Check out your water bill and how your water is running. If you find your kitchen dripping non-stop and your water bill going higher, you may have a leak! Let Parker & Sons put a stop to those leaks. Our team of expert plumbers will make sure to get the work done faster, get it right the first time, and do it efficiently.
Because your plumbing system is so important, our Oahu plumber is honored by the fact local residents and businesses have trusted us with all of their plumbing needs for over three decades. We believe that we have been so successful because in every project we undertake we strive to honor the trust Oahu has shown in us by putting our best effort forward to provide the highest quality plumbing services. Our Oahu plumber would be excited to continue this tradition of excellence with during your next plumbing project.
^ Jump up to: a b Joseph O. Falkinham III; Elizabeth D. Hilborn; Matthew J. Arduino; Amy Pruden; Marc A. Edwards (August 2015). "Epidemiology and Ecology of Opportunistic Premises Plumbing Pathogens: Legionella pneumophila, Mycobacterium avium, and Pseudomonas aeruginosa". Environ Health Perspectives;. 123 (8). doi:10.1289/ehp.1408692. Archived from the original on May 31, 2015. Retrieved August 1, 2015.
Plumbers on the Handy platform have experience in fixing all the common (and uncommon) plumbing problems that plague homes. Whether you’ve got a water heater leaking, a clogged toilet, or a blocked drain, chances are that your plumber will have seen and dealt with a similar job before. When you use the Handy app or website, you’ll be connected to experienced plumbers who’ll know exactly what to do, no matter how big or small the job might be.
When a plumbing emergency happens, a plumber must be contacted immediately to help sort of the problem. A plumber who goes to a house that has a major water leak can turn off the water to help stop the home from being damaged further. This gives the homeowner a chance to begin cleaning up while the plumber gets to work handling the leak and getting the water turned back on. Any time when the home is being flooded, it is best for an emergency plumber to be called immediately.

We actually have our own guide on this, but the above video from Lowe's is a good basic guide too. Do make sure to read the installation instructions that come with the faucet, though. Sometimes, there are important variations. We've only included a video on kitchen sinks here because the process of installing a bathroom sink is largely the same. However, you can always check out this video from RONAinc if you want to see the process.
The straight sections of plumbing systems are called "pipes" or "tubes". A pipe is typically formed via casting or welding, whereas a tube is made through extrusion. Pipe normally has thicker walls and may be threaded or welded, while tubing is thinner-walled and requires special joining techniques such as brazing, compression fitting, crimping, or for plastics, solvent welding. These joining techniques are discussed in more detail in the piping and plumbing fittings article.
×