Wooden pipes were used in London and elsewhere during the 16th and 17th centuries. The pipes were hollowed-out logs, which were tapered at the end with a small hole in which the water would pass through. The multiple pipes were then sealed together with hot animal fat. They were often used in Montreal and Boston in the 1800s, and built-up wooden tubes were widely used in the USA during the 20th century. These pipes, used in place of corrugated iron or reinforced concrete pipes, were made of sections cut from short lengths of wood. Locking of adjacent rings with hardwood dowel pins produced a flexible structure. About 100,000 feet of these wooden pipes were installed during WW2 in drainage culverts, storm sewers and conduits, under highways and at army camps, naval stations, airfields and ordnance plants.
Two-handle faucets are most often found in the bathroom, but you see them in some kitchens. Two-handle faucets use three types of mechanisms. The first two are the same as two of the mechanisms used in a single-handle faucet: cartridge and ceramic disc. The third type is a compression (or reverse-compression) mechanism. Compression faucets are the simplest type, using rubber washers that get compressed against one another to seal the valve. They do tend to wear out faster than other faucet types, but are also least expensive to repair.
Plumbers in Australia have licensing requirements that differ from state to state but it is generally accepted a 4-year apprenticeship with a further minimum experience of 2 years (6 years total) and a further curricular requirement as a benchmark for licensing. Licensed plumbers are also expected to maintain minimum relevant training requirements to maintain their plumbing license