Pro Plumbers

Plastic pipe is in wide use for domestic water supply and drain-waste-vent (DWV) pipe. Principal types include: Polyvinyl chloride (PVC) was produced experimentally in the 19th century but did not become practical to manufacture until 1926, when Waldo Semon of BF Goodrich Co. developed a method to plasticize PVC, making it easier to process. PVC pipe began to be manufactured in the 1940s and was in wide use for Drain-Waste-Vent piping during the reconstruction of Germany and Japan following WWII. In the 1950s, plastics manufacturers in Western Europe and Japan began producing acrylonitrile butadiene styrene (ABS) pipe. The method for producing cross-linked polyethylene (PEX) was also developed in the 1950s. Plastic supply pipes have become increasingly common, with a variety of materials and fittings employed.
Think that by calling for plumbing services you will have to clean up after the work is done? Not when you work with us! At Bud’s Plumbing & Repair Service, our uniformed plumbers arrive at your door with shoe covers and are conscious of the cleanliness of the work area. In fact, once the job is done, you won’t be able to tell we were even there! That’s how clean we leave your property. There is no mess for you to clean up, so you can get back to your normal routine without hassle.
Plastic pipe is in wide use for domestic water supply and drain-waste-vent (DWV) pipe. Principal types include: Polyvinyl chloride (PVC) was produced experimentally in the 19th century but did not become practical to manufacture until 1926, when Waldo Semon of BF Goodrich Co. developed a method to plasticize PVC, making it easier to process. PVC pipe began to be manufactured in the 1940s and was in wide use for Drain-Waste-Vent piping during the reconstruction of Germany and Japan following WWII. In the 1950s, plastics manufacturers in Western Europe and Japan began producing acrylonitrile butadiene styrene (ABS) pipe. The method for producing cross-linked polyethylene (PEX) was also developed in the 1950s. Plastic supply pipes have become increasingly common, with a variety of materials and fittings employed.
The difference between pipes and tubes is simply in the way it is sized. PVC pipe for plumbing applications and galvanized steel pipe for instance, are measured in IPS (iron pipe size). Copper tube, CPVC, PeX and other tubing is measured nominally, which is basically an average diameter. These sizing schemes allow for universal adaptation of transitional fittings. For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing. 1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded male or female adapter to connect them. When used in agricultural irrigation, the singular form "pipe" is often used as a plural.[19]

PBT – flexible (usually gray or black) plastic pipe which is attached to barbed fittings and secured in place with a copper crimp ring. The primary manufacturer of PBT tubing and fittings was driven into bankruptcy by a class-action lawsuit over failures of this system.[citation needed] However, PB and PBT tubing has since returned to the market and codes, typically first for "exposed locations" such as risers.

It’s a family event in late October when many American households carve a pumpkin into a Halloween jack-o-lantern. The kids delight in the whole process, especially when mom and dad let junior scoop the pumpkin pulp out of the pumpkin. But what happens next is the scary part. Often, those slimy pumpkin guts are pushed down the sink drain then the disposal is turned on to chop it into tiny bits before the water washes it away. Except, it doesn’t quite ... Read More >
Two-handle faucets are most often found in the bathroom, but you see them in some kitchens. Two-handle faucets use three types of mechanisms. The first two are the same as two of the mechanisms used in a single-handle faucet: cartridge and ceramic disc. The third type is a compression (or reverse-compression) mechanism. Compression faucets are the simplest type, using rubber washers that get compressed against one another to seal the valve. They do tend to wear out faster than other faucet types, but are also least expensive to repair.
The Home Depot has a wide selection of high-quality plumbing parts including sump pumps, water heaters, HVAC systems, pipes and much more. The Home Depot even has eco-friendly plumbing options to help you save money and live green. If you need professional advice or installation assistance with any of your plumbing projects, turn to The Home Depot to help you finish your plumbing project. 

Water heaters are tasked with heating the water that passes through the pipes to every shower, tub, and sink. These heaters are also supposed to heat water for the washing machine and dishwasher. These units can hold up for a long time, but may begin to cause problems over time. When the heater does not heat water properly all the time, leaks, or makes odd noises, homeowners will know that there is a problem. A water heater that begins to leak could start flooding the house at any moment. A water heater that makes odd sounds could be under pressure and about to burst. In each of these cases, it could be dangerous for the homeowner, and only a licensed Manhattan plumber can fix the problem or replace the water heater altogether.

“Central Penn Plumbing provided outstanding customer service. On a cold winter Saturday morning, we woke up to a very cold house. I gave Central Penn (Scott) a call and within an hour he had a service technician at our house to address the issue. Not only did they resolve the issue on the weekend, but Scott stopped by later in the week to ensure that things were still ok. Outstanding customer service. Thanks Central Penn Plumbing Services!”


Most typical single family home systems won't require supply piping larger than 3⁄4 inch (19 mm) due to expense as well as steel piping's tendency to become obstructed from internal rusting and mineral deposits forming on the inside of the pipe over time once the internal galvanizing zinc coating has degraded. In potable water distribution service, galvanized steel pipe has a service life of about 30 to 50 years, although it is not uncommon for it to be less in geographic areas with corrosive water contaminants.


For many centuries, lead was the favoured material for water pipes, because its malleability made it practical to work into the desired shape. (Such use was so common that the word "plumbing" derives from plumbum, the Latin word for lead.) This was a source of lead-related health problems in the years before the health hazards of ingesting lead were fully understood; among these were stillbirths and high rates of infant mortality. Lead water pipes were still widely used in the early 20th century, and remain in many households. In addition, lead-tin alloy solder was commonly used to join copper pipes, but modern practice uses tin-antimony alloy solder instead, in order to eliminate lead hazards.[13]
×