When a plumbing emergency happens, a plumber must be contacted immediately to help sort of the problem. A plumber who goes to a house that has a major water leak can turn off the water to help stop the home from being damaged further. This gives the homeowner a chance to begin cleaning up while the plumber gets to work handling the leak and getting the water turned back on. Any time when the home is being flooded, it is best for an emergency plumber to be called immediately.
My Mom is in her eightys. I called a plumber in Aug 2012, replaced the McDonnell/Miller LWCO low water cut off 47/2 $675.. Same plumber was called Jan 8,2013 back. He trouble shoot the problem and replaced the same unit, yet I still have the problem. After the heat come on for about 15 mins/ goes off.the pipes connecting to the MM LOCO the vibrating starts, shakes, and makes a loud noise. The boiler is steam, I know it's old. Do I call the same plumber or call someone differently?
My plumbing experience was to have the plumbing disconnected under the sink so the counter top and new sink could be installed. I thought the service of $115 was high, but usually if there is an additional fees, it is usually rolled into the cost of repairs or labor. This company also charged 3.75 % for putting it on a credit card, which was not mentioned until I received the invoice in the mail after paying on the phone.
Most typical single family home systems won't require supply piping larger than 3⁄4 inch (19 mm) due to expense as well as steel piping's tendency to become obstructed from internal rusting and mineral deposits forming on the inside of the pipe over time once the internal galvanizing zinc coating has degraded. In potable water distribution service, galvanized steel pipe has a service life of about 30 to 50 years, although it is not uncommon for it to be less in geographic areas with corrosive water contaminants.
The thicknesses of the water pipe and tube walls can vary. Pipe wall thickness is denoted by various schedules or for large bore polyethylene pipe in the UK by the Standard Dimension Ratio (SDR), defined as the ratio of the pipe diameter to its wall thickness. Pipe wall thickness increases with schedule, and is available in schedules 20, 40, 80, and higher in special cases. The schedule is largely determined by the operating pressure of the system, with higher pressures commanding greater thickness. Copper tubing is available in four wall thicknesses: type DWV (thinnest wall; only allowed as drain pipe per UPC), type 'M' (thin; typically only allowed as drain pipe by IPC code), type 'L' (thicker, standard duty for water lines and water service), and type 'K' (thickest, typically used underground between the main and the meter). Because piping and tubing are commodities, having a greater wall thickness implies higher initial cost. Thicker walled pipe generally implies greater durability and higher pressure tolerances.
toilets work off of siphon.more correctly it's the timely transfer of water from the tank to the bowl through the ports that starts the siphon and carrys the solids and water downstream,thus completing a flush.i also live in florida and due to lots of hard water everywhere can tell you that most likely the toilets are full of deposits and need to be replaced or are of poor quality.all of the toilets from home depot are trash i would suggest getting one from the factory or from a plumbing supply house.DO NOT GET A 1.28gpf...1.6gpf is still legal
I needed to hire a painter for my place of business which is a hair salon. I hired Jose and he was just fantastic! His communication was very thorough and he was on time and he did a wonderful job. I actually needed him to repaint the room from a prior painter who did a very sloppy job. Jose made my room look bright and beautiful and on top of it he cleaned everything so thoroughly. He wanted to leave my room spotless and I could tell he took a lot of pride in his services. I was very impressed with his work and I have already hired him to do a plumbing job next in my salon. He is the nicest guy you want to work with and he has an excellent work ethic. He is very upfront and honest he will tell you what he can or cannot do and his prices are very fair. Jose is going to be my go to guy for any handyman work I need in my salon going forward. I highly recommend him for whatever your handyman needs maybe. This man is a true professional!
Plumbers in Australia have licensing requirements that differ from state to state but it is generally accepted a 4-year apprenticeship with a further minimum experience of 2 years (6 years total) and a further curricular requirement as a benchmark for licensing. Licensed plumbers are also expected to maintain minimum relevant training requirements to maintain their plumbing license