Todd did an amazing job, and fixed a problem that could of been devastating. Replacing a leaking water heater and also a replacing a failing, leaking main shut of valve. The possibility of major flooding was a real danger It was a 12 unit townhome which made the job even trickier, as water had to be shut off to the entire building while he fixed the valve. Todd, replaced them quickly and expertly, without a hitch. Plumbing repairs are never fun for a homeowner, but these people (especially Todd) do great work. It is definitely a weight lifted off my chest.
Most states and localities require plumbers to be licensed. Although licensing requirements vary, most states and localities require workers to have 2 to 5 years of experience and to pass an exam that shows their knowledge of the trade and of local plumbing codes before they are permitted to work independently. In addition, most employers require plumbers to have a driver’s license.
Wall thickness does not affect pipe or tubing size. 1/2" L copper has the same outer diameter as 1/2" K or M copper. The same applies to pipe schedules. As a result, a slight increase in pressure losses is realized due to a decrease in flowpath as wall thickness is increased. In other words, 1 foot of 1/2" L copper has slightly less volume than 1 foot of 1/2 M copper.
I had called Ben Franklin to fix a pin hole leak in the meter horn. Booking an appointment was very easy and the crew (Sid and Brandon) showed up on time. They quickly found out that a stop valve was not working and had to be replaced as well. Sid clearly explained my options and the charges upfront. He dealt with the city for water shut off, went about the job in a quick and efficient manner. Sid was very professional and explained clearly what he was doing. He patiently answered all my questions. Brandon was very practical and frank. As they were finishing up (I had to leave the house for an hour) they spotted a leak in another valve and fixed that also. I thought it was highly ethical of them to do so. Thank you Sid and Brandon!
Two-handle faucets are most often found in the bathroom, but you see them in some kitchens. Two-handle faucets use three types of mechanisms. The first two are the same as two of the mechanisms used in a single-handle faucet: cartridge and ceramic disc. The third type is a compression (or reverse-compression) mechanism. Compression faucets are the simplest type, using rubber washers that get compressed against one another to seal the valve. They do tend to wear out faster than other faucet types, but are also least expensive to repair.