Pro Plumbers

I have no problem paying for any service I receive but when Allied Reddi-Rooter came into my home and immediately tell me and them tell me it would cost me 350.00 for them to install a new Rheem water heater (his recommendation) that cost 409.00 I have a problem. If the cost is exactly how Home Advisor indicates then he’s charging 350.00an hour.  I did my homework checked with other plumbers and it. Would not take an hour to remove old and install the new water heater. Thank Goodness I did my research won’t be using their services and I will be letting others know what happen to me. Shame on you Allied
Plumbing professionals on the Handy platform offer permanent solutions to plumbing problems, saving you time and money. With their experience and expertise, they'll be able to protect you against a range of hazards, such as exposure to foul water and even flooding. Often, these hazards are caused by an unqualified homeowner, thinking they can tinker their way to success. Using a professional plumber, you don't need to run those risks. However, Handy isn't just for the big jobs—you can book a plumber for work of any size. Whether you need a clogged drain dealt with or a full-scale water heater installation, booking plumbing services through Handy ensures that the job is done right the first time.
PBT – flexible (usually gray or black) plastic pipe which is attached to barbed fittings and secured in place with a copper crimp ring. The primary manufacturer of PBT tubing and fittings was driven into bankruptcy by a class-action lawsuit over failures of this system.[citation needed] However, PB and PBT tubing has since returned to the market and codes, typically first for "exposed locations" such as risers.
My Mom is in her eightys. I called a plumber in Aug 2012, replaced the McDonnell/Miller LWCO low water cut off 47/2 $675.. Same plumber was called Jan 8,2013 back. He trouble shoot the problem and replaced the same unit, yet I still have the problem. After the heat come on for about 15 mins/ goes off.the pipes connecting to the MM LOCO the vibrating starts, shakes, and makes a loud noise. The boiler is steam, I know it's old. Do I call the same plumber or call someone differently?
Clogged drains are no fun. We've shown you several ways to clear a clogged drain and how to clear a blocked P-trap under a sink, but bathtub drains can be a little more challenging. A lot more hair and other gunk goes down them than you think. Add to this the fact that most bathtub drains take a 90-degree turn that makes getting a drain snake down them more difficult.
I called BL Plumbing when a small leak started coming out of my shower. They responded quickly and Billy arrived in the afternoon. He diagnosed the problem and proposed a solution including cost. I approved and he went straight to work. Within the hour, the problem was resolved. Billy recommended work that was needed to reduce water pressure for the entire house. I approved the work including cost and Billy had that problem fixed quickly and efficiently. A small leak in the pipe below the shower led to a much needed home improvement. As we finished, Billy and I discussed potential future work and issues regarding maintenance concerning the overall projects completed that day. The entire process was a very positive experience.
Let's start with the easiest possible project: Installing a new shower head is as simple as it gets. Typically, all you have to do is unscrew the old shower head from the shower arm (the pipe coming out of the wall), clean off the threads on the shower arm and wrap a bit of Teflon tape around it, then screw on the new shower head. It's really that simple (and if you don't believe me, check out the video above from Dummies.com). Do read the installation instructions on the shower head you buy, though. Some are designed not to require Teflon tape and can actually leak if you use it.
Hi Ginger, We're sorry you had this experience with a plumber in our network. Have you left the review for the company? We encourage homeowners to share their experiences so others have an honest idea of the company they are hiring. If you would like to speak with a rep regarding your concerns please reach out to [email protected] If you have a review you would like to submit please send it to [email protected] or visit this link: http://www.homeadvisor.com/write-a-review/. -HASupport
Welcome to Flat Rate Plumbing Company. When you need an experienced and professional plumber, look no further than Flat Rate Plumbing Company. Our team has been serving Grand Prairie for more than 20 years with fast, affordable and reliable Flat Rate Plumbing Company. When you need a drip, leak, or blockage fixed you can trust Flat Rate Plumbing Company to solve your plumbing problems fast — the first time.
JAG PLUMBING PRODUCTS is very pleased to partner JAG PLUMBING PRODUCTS is very pleased to partner with BRIGGS Plumbing Products USA to act as the direct distributor of the prestigious BRIGGS and Sayco Brand line of Repair Parts. This 2-pack of Toilet tank flappers are the exact replacement required to fix your BRIGGS Toilet. JAG PLUMBING PRODUCTS strives ...  More + Product Details Close

Welcome to Atlanta Plumber Repair, offering you with plumbing services in the Atlanta area and surrounding areas as well. If you are looking for residential plumbing services along with reliable commercial plumbing services, the one company in Atlanta that will be able to assist you is the one company that can offer you all this for a great and affordable price, Atlanta Plumber Repair. All of our plumbers that are with us, are either trained and fully licensed or backed with our over 25 years of plumbing experience to get you the right type of plumbing treatment for your home that you are looking for.

Baker Brothers Plumbing offers both residential and commercial plumbing services including tank and tankless water heater replacement and maintenance; drain and sewer repairs or replacement; drain cleaning, clearing and jetting; pipe lining and pipe replacement; repipe; gas line repair; slab leak detection and slab leak repair; bathroom and kitchen faucet installation; garbage disposal repair and installation; and most general plumbing repairs in most or all of the following Dallas, TX ZIP Codes: 75229, 75230, 75225, 75220, 75209, 75219, 75247, 75212, 75235, 75201, 75207, 75248, 75287, 75252, 75244, 75254, 75240, 75251, 75248-1713, 75214, 75228, 75243, 75238, 75218, 75206, 75231, 75204, 75226, 75246, 75227, 75208, 75217, 75232, 75224, 75211, 75241, 75215, 75233, 75253, 75216, 75223, 75237, 75249, 75203, 75210
I had 207 Plumbing come to fix a leak in my ceiling.  It's a terrible, terrible company to do business with.  He came and fixed a broken pipe in the ceiling, and I asked him to check the rest of the pipe to make sure that nothing else was broken, he said everything was OK and charged me $219.00 for 45 minutes and left.  Never cleaned up his mess.  I went to clean up the mess after he left and found there was more damage to the pipe.  I called him to come back, which he did.  He looked at the water coming down from the ceiling, into a light fixture and said he had another job to go to and couldn't come back until next week.  He also wanted to charge me $350.00 to come back.  I told him that was too much and he said he would make an exception and only charge me $219.00.  Now I have major damage done to the ceiling, the light fixture and the floor.  All of this could have been prevented if he had stayed and fixed the problem.  I will NOT hire him again.
 CON'T FROM COMMENTS EARLIER.  However,  the  installation took less than 3/4/ hour and was a basic regulator with no other function.  Looking up the price afterwards, invoice did not list type or price, it appears that it would have cost me around $60 for the regulator and another $15 or so for the additional supplies necessary to install it and it was really a rather simple job with easy access.    Given that, it seems that $300 for less that  an hours worth of on site work,  company says it does not include commute time in its prices, is a little high.  While flat rate quotes are nice, they must take into consideration situations where the work load differs depending on the circumstances.  Therefore, unless you are at the upper end of the harder work needed than the average job. it can be argued that my estimated price of $300 for labor was more than a little high.  Maybe I am wrong since I have not used their services for years and  am not knowledgeable of the costs of equipment and professional labor today.  

Using corrosive chemicals to dissolve a clog is like throwing a grenade down a gopher hole. Instead, Wroblewski recommends flushing your drains weekly with a half cup of baking soda and one cup of vinegar. Let it fizz in the drain for ten minutes, then pour in four cups of boiling water. Find out about the plumbing nightmares that will make you cringe.


Some allege that putting a brick in the toilet tank can save water, but doing that can keep your toilet from flushing correctly. Another plumbing tip, avoid liquid drain cleaners. Liquid drain cleaners are also bad news—they eat away at the pipes. Try a plunger or, better yet, a $30 auger. Don’t have either? Here’s how to unclog a toilet without a plunger.
The Oatey 8 oz. Handy Pack Purple Primer The Oatey 8 oz. Handy Pack Purple Primer and Solvent Cement contains code-listed primer and solvent cement needed for solvent-welding PVC pipe and fittings. Can be used with up to 4 in. Dia piping. Convenient Handy Pack for storage - just add pipe and fittings. Due to the nature of ...  More + Product Details Close

Altstadt’s highly trained licensed Evansville plumbers offer a variety of fast, reliable local plumbing services for your home or business. We offer quality service and specialize in new construction, commercial, industrial, residential, remodeling, and emergency repairs. Whatever the job, you can count on us to get it done right and as efficient as possible. At Altstadt, we believe in providing high quality service at a competitive price. Our goal is your satisfaction!
B&L Plumbing Service, Inc. offers a variety of residential and commercial plumbing services in the Kansas City metro area. We are a family owned and operated business and have been satisfying our customers since 1998. At B&L Plumbing, we go above and beyond to take care of our customers and are always ready to take care of any problem that you may have with your plumbing systems. We know your time is valuable. That is why when you call, we will arrive when you need us with a skilled service technician and a well stocked truck ready to troubleshoot, and repair your plumbing problem on the spot.

I think it is rather rude and a bit dishonest for people to not divulge their total fees upfront, an of course we should know to ask. But the normal person wouldn't know the questions to ask until they are burnt once like this, and then there still could be costs for walking up stairs or charge another service call if they need to go somewhere to use the bathroom and come back. THAT ISN'T A QUESTION I WOULD THINK TO ASK.
I just had my pipe under the sink unclogged  and new pipes put in $600.00, then they flushed out the pipe from under the sink to the outside pipe $700.00, Total of $1.600.00, I thought that the price was high, I got the plumber from Home Advisors, not sure they had to do all they did but they said I needed the work done.  The same evening hike using the dishwasher I had a leak in one of the pipes they put in, they came back the next day to fix it. Don't know if I will use them again.. They were K&D kitchens.
Our plumbing, heating, and air conditioner services range from basic repair and maintenance to extensive sewer line replacements and remodels. Your comfort and safety is our company’s main concern. Our plumbing and HVAC technicians will assess your home’s systems and perform the necessary service to return your plumbing, heating or cooling system to full capacity.
I thought that my sump pump had ended its life and needed to be replaced. The contractor I found through Home Adviser came out the following day and arrived reasonably promptly.  The technician tested the pump and it wasn't responding. He then checked the  breaker panel and all seemed well. However he checked to see if power was reaching the outlet, it wasn't so he tripped some breakers and reset them and the power to my pump came on and the pump works so a replacement wasn't necessary. He charged $75.00 which I think was reasonable for a call-out fee and time spent.
Wall thickness does not affect pipe or tubing size.[20] 1/2" L copper has the same outer diameter as 1/2" K or M copper. The same applies to pipe schedules. As a result, a slight increase in pressure losses is realized due to a decrease in flowpath as wall thickness is increased. In other words, 1 foot of 1/2" L copper has slightly less volume than 1 foot of 1/2 M copper.[citation needed]
×