Before you get involved with most plumbing projects, you'll need to shut off the water flowing to whatever you're working on. Most of the time, there are easy-to-access gate valves or compression valves that you can turn with your hand. Turn them clockwise all the way to turn off the water and counter-clockwise to turn it back on when you're done. For sinks, look under the sink and you'll usually see two valves—one for hot water and one for cold. On kitchen sinks, you might also see valves for the ice maker on your fridge or your dishwasher. Just turn them all off. For toilets, the valves are on the wall or right on the pipe behind the toilet.
I thought that my sump pump had ended its life and needed to be replaced. The contractor I found through Home Adviser came out the following day and arrived reasonably promptly. The technician tested the pump and it wasn't responding. He then checked the breaker panel and all seemed well. However he checked to see if power was reaching the outlet, it wasn't so he tripped some breakers and reset them and the power to my pump came on and the pump works so a replacement wasn't necessary. He charged $75.00 which I think was reasonable for a call-out fee and time spent.
Most plumbers wont mess with the septic tank. We deal mostly with components inside the house. Did you have a vent pipe in the yard (often looks like a candy cane made of PVC) before the repair but not after? If all he did was replace the line it shouldn't cause a smell inside the house. All plumbing fixtures inside the house should have properly functioning traps. Those traps would create and maintain a water seal against the sewer gases. You should have at least one vent through the roof to equalize pressures within the drainage system. This prevents positive pressures within the system (caused by fixtures discharging into the lines, ie toilet flush) from pushing gas out through the traps, and negative pressures (the waste in line will pull air behind it like your finger over the end of a straw) from sucking water out of the traps.
It’s impossible to maintain your desired levels of comfort at home or work without the proper plumbing equipment. From hot showers and reliable kitchen appliances to properly flowing sewer lines and leak-free properties, the right plumbing system can keep you from dealing with a heap of plumbing headaches. Leave it to the plumbing professionals to ensure your equipment operates year-round.
No plumber is going to come right out and explain that they don’t have the required license to work for you. So if you know someone who is a great plumber, but they don’t have a license, hire them at your own risk. Licensed plumbers know the local building codes and regulations, have completed a certain amount of hours on the job and are insured. Want to become a master plumber yourself? Here are 28 tips.
Water systems of ancient times relied on gravity for the supply of water, using pipes or channels usually made of clay, lead, bamboo, wood, or stone. Hollowed wooden logs wrapped in steel banding were used for plumbing pipes, particularly water mains. Logs were used for water distribution in England close to 500 years ago. US cities began using hollowed logs in the late 1700s through the 1800s. Today, most plumbing supply pipe is made out of steel, copper, and plastic; most waste (also known as "soil") out of steel, copper, plastic, and cast iron.
Plumbers in Australia have licensing requirements that differ from state to state but it is generally accepted a 4-year apprenticeship with a further minimum experience of 2 years (6 years total) and a further curricular requirement as a benchmark for licensing. Licensed plumbers are also expected to maintain minimum relevant training requirements to maintain their plumbing license